Ceracell | Beast Blocker Entrance Protector
The Beast Blocker® is the most effective entrance protector for your beehive.
With the Beast Blocker® in place at the entrance to your hive you have:
- Stopped hornets and wasps from sneaking in and stealing honey and killing brood.
- Stopped robbing bees from overwhelming your guard bees and stealing honey.
- Stopped mice from moving in and eating honey, pollen, and beeswax.
- Potential to reduce access of SHB.
- Minimized bee drift which can reintroduce varroa, so your varroa treatments stay effective for longer.
- Minimized bee drift which can introduce AFB and EFB.
- Stopped predator invasions which result in your guard bees doing their duty and dying to protect the hive. Over time, this can leave your hive defenceless and reduce your bee population.
- An easy and effective way to close the hive entrance so no bees can leave, while still having excellent front ventilation.
The Beast Blocker® works by training the bees in your hive to do a 90° turn when they exit the hive and leave by crawling up the front of the brood box. There is still ventilation along the front of the hive, so invaders still smell and hear the hive at the usual entrance but can’t get in along the front face.
The best time to install the Beast Blocker® is very early in the morning before the bees start flying.
The Beast Blocker® comes with a translucent front plate and two coloured entrance gates, which can swing and click fully open or fully closed (usually these are already in place), and will require 7 screws. The front plate of the Beast Blocker® has “score marks” near each end of the base. If you have an 8-frame hive, cut the base plate at these score marks so that your Beast Blocker® will fit your 8-frame hive.
Check that you have all the parts of the Beast Blocker® assembled with the left and right entrance gates securely snapped into place.
- Get one screw out and loosely thread it into the centre hole between the two entrance gates until the sharp end is just poking through the centre hole.
- With one hand, place the Beast Blocker® on the front of your hive, with the entrance gates at the top and the long base at the bottom. Make sure the gates are in the closed/down position to ensure they sit flush against the face of your hive while you install it.
- Make sure that the bottom grill of the plate is hard against the bottom along the landing board of the hive with no gaps.
- While holding the Beast Blocker® in place, screw the central screw into the front of your hive. It is important you start here and not the screws on the side.
- Then use 6 screws to finish screwing the Beast Blocker® in place securely using the 6 strategically supplied holes. Make sure the base plate and closing gates are flush against the super when screwing it in to ensure the gates can function as designed.